4.3" TFT Touch LCD

From SainSmart Wiki
Jump to: navigation, search
4.3 inch tft lcd

Description:

This is Sainsmart 4.3 inch TFT LCD module,It is 100% compatible with the normal MCU like ARM AVR PIC and 8051,especially on arduino family such as arduino due and arduino mega2560(R3).The module uses the LCD controller Chip SSD1963 with 4.3 inch LCD including the touchscreen.We will provided you the whole document including the example project of arduino mega2560 R3/due with the 4.3 inch TFT LCD.We will supply you the technical support after your purchase.

Specification

  • 4.3" TFT LCD Module, Resolution 480x272, SSD1963 Controller
  • Resist film to protect the LCD screen
  • LCD Type: TFT Transmissive Normal White super wide viewing angle
  • LCD Panel: HannStar HSD050IDW1
  • Interface: 8/16bit parallel bus interfacePCB
  • Color: BlackOn board DC-DC Boost regulator TPS61040 to provide power supply to LCD back-light
  • With SD Cage and Flash IC footprint reserved
  • LCD-specified initialization code is provided, so that you can save time to optimize power control register and gamma curves for best display performance. We have test the provided code, it gives the best display performanace
  • Module dimension: 133mmx85mmx23mm(including pin header extrusion)
  • Active Area: 95.06mmx52.86mm
  • Pixel pitch: 0.135mmx0.135mm
  • Standard 2x20 2.54mm pin header for connection to MCU/development board

For Mega2560

1.This is SainSmart TFT LCD shield for Arduino MEGA2560,the sale page please click here.

2.You can download this shield schematic here.

Mega2560 shield.jpg 4.3inch install.png

Download Code and Upload

1.You can download Arduino Software (IDE) here

2.Download libraries here.Then put the UTFT and UTouch folder from Mega folder into the IDE libraries folder. Then run IDE.

For display

1.Open the File /Examples/UTFT/Arduino(AVR)/UTFT_Demo_480x272.ino .

4.3inch display.png

2.Choose the right board and Port, upload the ino file into the MEGA ,then reset the board .The graphics could be seen then.

4.3inch display2.png

For touch

1.Open the File/Examples/UTouch/Arduino/UTouch_Calibration.ino .

4.3 calibration1.png

2.Choose the right board and Port, upload the ino file into the MEGA ,then reset the board .The graphics could be seen then.

4.3 calibration2.png

3.Click on the screen,then the following screen will appear:

4.3 calibration3.png

4.Follow the screen instructions to calibrate operation

4.3 calibration4.png

5.Open the file Arduino/libraries/UTouch/UTouchCD.h,and change the follow:

4.3 change3.png

6.After calibration,you can try to use the other ino. Open the File/Examples/UTouch/Arduino/UTouch_ButtonTest:

Button1.png

7.Upload the ino file into the MEGA ,Then reset the board . The graphics could be seen then.

4.3 button2.png

Resources

How to buy it ?

You can click here to get lcd kit for mega.

You can click here to get lcd kit for due.

You can click here to get lcd kit for uno.